Login required to started new threads

Login required to post replies

Re: Official FIT ASSISTANCE for Cervelo TT and Triathlon Bikes [ericMPro]
Thanks Eric,

I sold that bike some years ago and I have no chance to measure pad stack, sorry. But looking at the pictures, based on the Felt DA frame stack of 497mm, I calculate about 80mm above the frame, which would be a pad stack of ~577mm




ericMPro wrote:
any chance you could measure your bike from the floor to the pads, and then subtract the distance from the floor to the center of the BB?

Based on your reach you'd be at the very back end of a size M P3x so you'd probably be better off on a size S. We can confirm when you get me a final number for stack.

Eric

baerospeed wrote:
Hi Eric,

Thanks for your answer.

I meant that the Felt DA size 54 had a frame stack of 497mm and a frame reach of 416mm. I was not meaning pad stack...




ericMPro wrote:
With a Pad Stack of 497mm you are below the minimum of a size Small P3x, which bottoms out at 540mm or so.

With a P5d you'd also bottom out at 540mm. Are you sure about your measurements?

Eric

baerospeed wrote:
Hi Eric,

I´m looking for a new bike and I really like the P3X/PX but I´m not sure about choosing size S or M.

I'm 173cm and I have 72cm of saddle height from BB.

I don't have fitting numbers but I have ridden a Felt DA size 54 in the past. My Felt DA had 497mm of stack and 416mm of reach. For your reference the pictures below show my position on the Felt DA size 54. As you can see there wasn't much seatpost out of the frame. I would not like that to happen in Cervelo P3X/PX. Any suggestions ?

Thanks,
Last edited by: baerospeed: Dec 3, 19 6:27

Edit Log:

  • Post edited by baerospeed (Big Pines) on Dec 3, 19 6:27